ADCA Packaged Equipment

ADCA PEquip – Complementary Equipment -Valsteam 2021-07-12T14:01:11+01:00

COMPLEMENTARY EQUIPMENT

Valsteam complementary equipment - as

AS

The AS series centrifugal air and dirt separators were designed to be used in the flow line of a hydronic heater or cooling system. The operation is based on the principle of centrifugal force, instead of relying on low-velocity separation, offering the advantage of efficient separation in a smaller vessel. The ADCA AS units provides maximum separation efficiency while minimizing space requirements.

MATERIAL: Carbon, zinc plated and stainless steel body

SIZES: 11/4” to 2”DN 32 to DN 300

CONNECTIONS:

Threaded ISO 7 Rp
Flanged EN PN16 or PN40
Flanged ASME Class 150 or 300
Special flanges upon request

MAX. OPERATING PRESSURE: 40 bar

MAX. OPERATING TEMPERATURE: 300 ºC

Valsteam complementary equipment - hcc

HCC

The HCC is a cooling device that allows the mixing of hot condensate with a lower temperature condensate, avoiding hammering. Condensate discharge from higher pressure lines (drip points, for instance) is often connected to low-pressure condensate lines, with lower temperatures. This sudden pressure drop will convert the sensible heat difference between the two fluid conditions into latent heat, generating flash steam.

MATERIAL: Carbon and stainless steel

CONNECTIONS:

Flanged EN PN16 or PN40
Flanged ASME Class 150 or 300
Others on request

MAX. OPERATING PRESSURE: 40 bar

MAX. OPERATING TEMPERATURE: 300 ºC

Valsteam complementary equipment - eh

EH

The EH series exhaust heads were designed to protect personnel from injury and exterior of buildings from harmful effects of steam ejection to atmosphere. The head is fitted at the end of a vertical exhaust pipe and effectively retains the moisture separated from the steam for draining.

MATERIAL: Carbon, zinc plated and stainless steel body

SIZES: 1” to 4” ; DN 25 to DN 250

CONNECTIONS:

Threaded ISO 7 Rp
Flanged EN PN16 or ASME Class 150

MAX. ALLOWABLE PRESSURE: 0,5 bar

Valsteam complementary equipment - lipo

LIPO

The LIPO series condensate lifting pots are used for rising condensate to elevated pipes, eliminating steam and water hammering.

MATERIAL: Carbon and stainless steel

SIZES: DN 15 to DN 100

CONNECTIONS: Flanged EN or ASME

MAX. ALLOWABLE PRESSURE: 18 bar

MAX. ALLOWABLE TEMPERATURE: 250 ºC

Valsteam complementary equipment - mas

MAS

The MAS series steam distribution manifolds are essentially designed to allow the placement of steam supply valves in a single location, reducing costs and providing easy control of different steam lines. The drain connection, with an automatic steam trap installed, discharges any condensate formed, thus providing high-quality dry steam.

SIZES: DN 100 to DN 300

CONNECTIONS:

Flanged EN PN 16 or PN 40
Flanged ASME Class 150 or 300
Threaded ISO 7 Rp or NPT on request