ProScan Radar Level Sensor
The ProScan Radar Level Sensor measures the liquid level inside a tank or sump by using a completely PTFE Teflon antenna or horn that sends and receives low energy radar pulses. The sensor is mounted to the top of the tank and the pulsed signal is reflected off the liquid surface, the echo (returned signal) is then picked up or received by the transmitters antenna. The time it takes is compared to known laws of physics (speed of light), once this is done the distance can be determined, and very accurately measured.
The ProScan radar level transmitterdoes not contact the process liquid and therefore is an excellent choice for applications that may be corrosive, coating, dirty, or crystallizing. The are temperature compensated over the entire range (-40-260°F) and can be used to measure liquid under pressure or in a vacuum. The ProScan Series is both reliable and accurate; there is no requirement for re-calibration, and virtually zero maintenance as there are no moving parts.
The ProScan utilizes a special microprocessor technology and mapping software that allows it to be used where other non-contact level sensing products fail or go lost i.e. Ultrasonics on Foam, Vapor, Condensate or Turbulence.
- PTFE Teflon Antenna (Horn)
- Low Profile
- Simple Programming
- Suitable for Foam | Vapor
- IP67 Housing
- Epoxy Coated
- 4-20mA Loop Power
- Plastic Design | Chemical Resistant
- Small Dead Band
- PTFE Antenna (Horn)
- Low Profile
- Simple Programming
- Suitable for Foam | Vapor
- Fail Safe Diagnostics
- Simple Configuration
- IP67 Housing
- Epoxy Coated Enclosure
- Loop Powered | 2 Wire
MLR-70 Guided-Wave Radar Level Sensor
The MLR guided-wave radar level sensors are compact level measurement devices that include a transmitter that emits microwave pulses along a rod or wire rope electrode. The pulse propagates along the electrode in the form of electromagnetic wave toward the level surface, where it is reflected and the signal wave component is returned to the receiving module of the electronic housing. The on-board circuitry measures the time of flight of electromagnetic wave and the distance to the surface level is calculated. According to the level height, the level meter output is set and the measured value is shown on the display. Radar level meters are resistant against changes in the atmosphere (pressure, temperature, dust, steam) and to changes in medium parameters (change in dielectric constant and conductivity).
- Suited for Continuous Level Measurement of various Liquid | Bulk Solids | Viscous Materials
- View Measured Values on the Display
- Universal Use | Direct Mounting onto Hoppers | Silos | Tanks | Sumps
- Teflon® Coated Stainless Steel Rod or Rope
- Electrode Measuring Range up to 40m
- Explosion Proof | ATEX (Optional)
- Current Output (4-20mA) | HART® Protocol
- FEP Teflon® Coated Probe
- High Accuracy
- Simple Programming
- LCD Display
- IP67 Housing
- 4-20mA Loop Powered
- Output signal: 4-20mA (Std) | 4-20mA+HART |
- Modbus | RS485
- Suitable for: Foam, Vapor, Condensate, Turbulence
- Liquid Chemical Storage
- Chemical Sumps